Embroidery Hoop; Instruction Book Rose - Husqvarna Viking Rose 605 User Manual

Embroidery hoop

1. Loosen the screw on the outer
hoop, place the outer hoop so
that the screw is down to the
right.
2. At the front edge of the hoop
there is an arrow.
3. A corresponding arrow is located
on the inner hoop as well as
center marks in the two
directions. You should take notice
of the back marks.
4. Place the embroidery template on
your fabric. Use the Pictogram™
pen to mark within the grooves
and in the center.
5. Place the inner hoop, the marks
matching the ones on the fabric.
Side marks should line up with
the top marks on the sides of the
hoop. We recommend using a
tear-away stabilizer in the hoop
under the fabric. Press hoop and
fabric down, stabilize fabric as
needed, into the outer hoop and
tighten the screw. The arrows of
the outer and the inner hoops
should both be at the bottom.
6. Slide the hoop under the presser
foot - raise up the presser foot
lever to take advantage of the
extra lift of the presser foot.
Slide hoop from the front onto
the embroidery arm.
Note: Always sew a sample
Embroidery on a scrap of the
same fabric you will embroider.
7. Raise the presser foot before
removing the embroidery hoop
from the machine. Press the
button located to the right on the
hoop and pull the hoop towards
you.

Instruction book Rose

Note: Always touch CLR before
you turn off the machine.
Otherwise the embroidery arm
will not come to the correct
position to remove the unit from
the machine.
29