Error Codes - MotoSAT Nomad SD User Manual

Code Description
0 NO ERROR
1 MOTOR, MOVING
2 INVALID MODE 1
3 INVALID MODE 2
4 MOTOR, TIMEOUT EL
5 MOTOR, TIMEOUT AZ
6 MOTOR, TIMEOUT SK
7 LIMIT ERROR, EL
8 LIMIT ERROR, AZ
9 LIMIT ERROR SK
10 TUNER FAILURE
11 AGC, NO LOCK
12 MAIN SAT ONLY FOUND
13 MAIN SAT NOT FOUND
14 UNUSED
15 UNUSED
16 NO SATELLITES FOUND
17 OVER TEMP (This code does not necessarily mean that the Nomad controller has a
problem. It indicates that the temperature within the working environment has exceeded a
normal operational level and could damage or affect normal operation of your electronic
equipment. Correct the over temperature problem and if problem continues, replace the Nomad
controller. This error means that you have been warned concerning damage to your other
electronics in the cabinet.
18 DISH HEIGHT ERROR
mount is binding.
19 COAX ERROR
20 UNUSED
21 UNUSED
22 GPS FAILURE
Search Routine using the last stored GPS data
23 NO MAIN AFTER SKEW
24 CRITICAL INTERNAL FAILURE
25 LNB POWER FAILURE
26 TUNER AMP ON, FAILURE
27 TUNER ID, FAILURE
28 MOTOR, FAILURE
29 COUNTER, FAILURE
30 MOUNT MISS-MATCH

ERROR CODES

Indicated by sequential flashing of the "FIND" LED
Critical Error =
- Improper configuration selection for the mount or the
– Reversed Coax cables on the back of the controller.
The FIND LED will blink for 5 minutes before beginning starting a
-
- Check sensors
- Check sensors
– Check Programming configuration
(Factory action required)
!
Probable cause
Normal Operation
Check Configuration
Check Configuration
Check sensors or Wiring
Check for obstructions
trees, buildings etc.
!
!
Check for obstructions
trees, buildings etc.
Check for obstructions
!
!
!
!
10