Deleting A 2-Way Wireless I/O Expander Module - Electronics Line iconnect Installation Manual
2-way wireless i/o expander
Hide thumbs
Also See for iconnect:
- Installation manual (140 pages) ,
- User manual (60 pages) ,
- User manual (52 pages)
Table of Contents
Advertisement
8.
Deleting a 2-Way Wireless I/O Expander Module
To delete a 2-Way Wireless I/O Expander Module from the system:
1.
Set the system to Delete mode.
•
Go to the main menu and select [9]>[1]>[6] (Programming > Devices >
Zone Expanders).
•
Select a 2-Way Wireless I/O Expander Module from the list (1-2) and
press '√ʹ.
Press >3, and then press '√ʹ. Upon the 'OK' confirmation request, press ʹ√ʹ
2.
3.
Open the plastic unit (see Figure 5-1 and Figure 6-1) and disconnect the main
AC power.
4.
Press the tamper switch. While the tamper switch is being pressed connect the
power. Within five seconds open the tamper and close it again.
10
Advertisement
Table of Contents
Need help?
Do you have a question about the iconnect and is the answer not in the manual?
Questions and answers