Prodigy
• Otras zonas además de la yema del dedo
Consulte la sección "Acerca de las pruebas en zonas alternativas
(AST)". Consulte con su profesional de atención médica antes de
extraer sangre de otras zonas además de la yema del dedo.
Precaución: El medidor autocodificado Prodigy
una pequeña muestra de sangre para realizar una prueba.
Elija un punto diferente cada vez que realiza la prueba. Repetir
las punciones en el mismo punto puede producir dolor y formar
callos.
PASO 3: Aplique un masaje suave en el área
No corra la muestra de sangre.
Para obtener los resultados de la prueba más
precisos, retire la primera gota de sangre y
extraiga suavemente una segunda gota de
sangre. Véase la figuras 28 y 29.
PASO 4: Retire la lanceta
Quite la lanceta con cuidado. Coloque la tapa
protectora nuevamente en la punta
expuesta de la lanceta.
*Siempre retire la lanceta con cuidado.
Deseche la lanceta según la reglamentación local.
Advertencia: La primera gota de sangre usualmente contiene
tejido, líquido y suero, lo cual podría afectar el resultado de
la prueba. Se la debe descartar.
Prodigy
Diabetes Care
®
Medidor parlante Manual del usuario
27
sólo requiere
®
Figuras 28 y 29
1.800.243.2636
Need help?
Do you have a question about the AutoCode and is the answer not in the manual?
Questions and answers
After ‘’please apply blood into the test strip’’ it shut immediately
The Prodigy AutoCode meter may shut off immediately after applying blood to the test strip if the test strip was not inserted correctly or if there was an issue with filling the strip properly. If the test strip is not in place when blood is applied, the meter will not function correctly. Ensure the strip is inserted with the chip side up before applying blood. If the issue persists, a new test strip may be needed.
This answer is automatically generated
Does any of your meters allow them to be sync to a computer?
Yes, Prodigy AutoCode meters allow syncing to a computer using a USB cable. When connected properly, “USb” will appear on the meter display, indicating successful communication with the PC.
This answer is automatically generated
I changed the batteries. Turned on. Placed a test strip and it shuts down