Prodigy AutoCode Owner's Manual page 33

Hide thumbs Also See for AutoCode:
Table of Contents

Advertisement

Available languages

Available languages

Prodigy
The 14-day average is calculated from the
blood glucose test results obtained during
the last 14 days. See Figure 36.
It, too, indicates how many blood glucose
tests have been performed, e.g., 41 (41
tests in the last 14 days). The 28-day
average shows the same information.
STEP 3: Recalling Individual Test Results
After the 28-day average, the most recent
test result with date and time will be shown.
Press the "M" button once and the next most
recent test result will appear. See Figure 37.
Each time you press and release the "M"
button, the meter will recall up to your last 120 test results
in order. When the memory is full, the oldest test result is
dropped as the newest is added.
After reaching the last individual result, it will return back to
the 7-day average.
STEP 4: Exit the Memory Mode
Press and hold the "M" button for two (2) seconds to turn
off the meter.
Important: If you do not press any buttons for one (1)
minute, the meter will display "OFF" and turn off
automatically.
Prodigy Diabetes Care, LLC
Talking Meter
31
Owner's Manual
Figure 36
Figure 37
1.800.243.2636

Hide quick links:

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AutoCode and is the answer not in the manual?

Questions and answers

Bernabas Feye
February 13, 2025

After ‘’please apply blood into the test strip’’ it shut immediately

1 comments:
Mr. Anderson
February 13, 2025

The Prodigy AutoCode meter may shut off immediately after applying blood to the test strip if the test strip was not inserted correctly or if there was an issue with filling the strip properly. If the test strip is not in place when blood is applied, the meter will not function correctly. Ensure the strip is inserted with the chip side up before applying blood. If the issue persists, a new test strip may be needed.

This answer is automatically generated

Walter E. Hayes
April 2, 2025

Does any of your meters allow them to be sync to a computer?

1 comments:
Mr. Anderson
April 2, 2025

Yes, Prodigy AutoCode meters allow syncing to a computer using a USB cable. When connected properly, “USb” will appear on the meter display, indicating successful communication with the PC.

This answer is automatically generated

Mmike
April 14, 2025

I changed the batteries. Turned on. Placed a test strip and it shuts down

Table of Contents

Save PDF