Viewing Results On A Personal Computer - Prodigy AutoCode Owner's Manual
Hide thumbs
Also See for AutoCode:
- Quick start manual ,
- Owner's manual (148 pages) ,
- Reference manual (42 pages)
Table of Contents
Advertisement
Available languages
Available languages
Prodigy
Viewing Results on a Personal Computer
Caring for Your Prodigy
Test results in the memory can be transmitted to your
personal computer. Prodigy
Software and a standard USB cable are needed before
installation.
STEP 1: Install Software
Install Prodigy
®
your computer by following the instructions provided at www.
prodigymeter.com.
STEP 2: Connect to a Personal Computer
Connect the USB Cable to your computer.
Connect the USB Cable to the Data Port
of the meter. "Lnk" will appear if the USB
cable is connected to the meter.
See Figure 38.
You can begin to download the data from
the meter. "USb" will appear on the display
indicating that the meter is successfully
communicating to your computer.
See Figure 39.
Prodigy Diabetes Care, LLC
Talking Meter
AutoCode Meter
®
Diabetes Management System
®
Diabetes Management System Software on
www.prodigymeter.com
32
Owner's Manual
Figure 38
Figure 39
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the AutoCode and is the answer not in the manual?
Questions and answers
After ‘’please apply blood into the test strip’’ it shut immediately
The Prodigy AutoCode meter may shut off immediately after applying blood to the test strip if the test strip was not inserted correctly or if there was an issue with filling the strip properly. If the test strip is not in place when blood is applied, the meter will not function correctly. Ensure the strip is inserted with the chip side up before applying blood. If the issue persists, a new test strip may be needed.
This answer is automatically generated
Does any of your meters allow them to be sync to a computer?
Yes, Prodigy AutoCode meters allow syncing to a computer using a USB cable. When connected properly, “USb” will appear on the meter display, indicating successful communication with the PC.
This answer is automatically generated
I changed the batteries. Turned on. Placed a test strip and it shuts down