NC2500S
2.3.3
Connecting the power cord of the projector
Insert the power cord (1φ)
[1]
of the projector main unit
into the power cord inlet.
Any power cord (single-phase) for the
main unit is not attached as accessory.
Use a cord suitable to the user
environment.
Connect the main unit
[2]
power cord (1φ) to the
noise filter terminal.
Any power cord (1φ) for the main unit is
not attached as accessory. Use a cord
suitable to the user environment.
(1) Japan; black, Euro/USA; Brown
(2) Japan; White, Euro/USA; Blue
GND; Green/Yellow
Upon connection completion, close the
terminal cover of the noise filter terminal.
• Mount the touch panel controller (separately sold), before mounting the cover of the
Memo
projector head. Refer to "touch panel" section about a procedure.
(2)
(1)
GND
2. Settifng Up Your Projector
(1)
(2)
Noise filter terminal
AC200-240V (single-phase)
50/60Hz
Terminal
cover
A-27