NC2500S
2.3.1
Removing the covers of the projector and LPSU
To connect the power cord, remove the covers of the projector and the lamp power supply
unit (LPSU).
Remove the top front cover
[1]
of the projector.
Remove the hexagonal fasteners at the
top (at 4 places) and remove the front
(lens side) cover.
Remove the top rear cover
[2]
of the projector.
Remove the hexagonal fasteners (2
places) at the top. Before removing the
top rear cover, it is necessary to remove
the cables of the rear status indicator. For
details, refer to "1.5.1. Top rear cover
removal procedure" (page A-17).
Remove the side front cover
[3]
of the projector.
Remove the hexagonal fasteners (2
places) on the side and remove the cover
with lifting it a little.
Remove the front cover
[4]
(bottom) of the projector.
Remove the hexagonal fasteners (2
places).
Remove the cover of the
[5]
lamp power supply unit.
Cover mounting screws are used at 7
places.
2. Settifng Up Your Projector
(2)
(1)
A-23