Commodore 128 System Manual page 286

just a dash, the Commodore 128 shows all lines from that number
to the end of the program. And if LIST is typed with a dash, then a
number, all lines from the beginning of the program to that line
number are LISTed. By using these variations, any portion of a
program can be examined or brought to the screen for
modification, ln Commodore 128 mode, LIST can be used in a
program.
EXAMPLES:
LIST
Shows entire program.
LIST 100-
Shows from line 100 until the end of the program.
LIST 10
Shows only line 10.
L IS T -100
Shows all line from the beginning to line 100 inclusive.
LIST 10-200
Shows lines from 10 to 200, inclusive.
LOAD
Load a program from a peripheral device such as the disk drive
or Datassette
LOAD["filename"] [.device number] [.relocate flag]
This is the command used to recall a program stored on disk or
cassette tape. Here, the filename is a program name up to 16
characters long, in quotes. The name must be followed by a
comma (outside the quotes) and a number which acts as a
device number to determine where the program is stored (disk or
tape). If no number is supplied, the Commodore 128 assumes
device number 1 (the Datassette tape recorder).
17-44