V100 Screen Display Sequence: Bi-Level Memory - Vetta V100 User Manual

Button #3 Starts and stops the timers and Stopwatch and is
used to reset timers and other ride data to zero.
Exits Normal Operating Mode (NOM) Setup and
advances to NOM System Check and SPD/DST
screen mode.
Note: To enter Setup in the Normal Operating Mode:
1.Make sure the timers are turned off. 2.Go to
SPD/DST screen mode. 3.Press and hold Buttons
#1 and #2 simultaneously for 2 seconds.
V100 SCREEN DISPLAY SEQUENCE:
BI-LEVEL MEMORY
The V100 series computers are programmed with a Bi-Level Memory
which returns to the last screen function accessed between the
upper and lower screen modes. See illustration for this sequence and
how to advance from one screen to the next.