Vetta V100 User Manual page 26

SETUP: SYSTEM CHECK
After the Programmable Odometer is set, both the Initial and
Normal Operating Mode Setup programs will automatically
advance to the System Check screen sequence. System Check
displays all value and unit settings chosen during Setup in a 4
screen sequence. Each screen appears for 5 seconds and will
blink. When the review is complete, the computer automatically
exits Setup and enters the SPD/DST screen mode. To correct any
value or unit errors, reenter the NOM Setup program.
SETUP: ODOMETER
Bike I and Bike II have separate odometers. On a
new computer the Odometer screen should
read "00000" for both. To confirm this initial zero
setting, simply press Button #1 successively to
select each flashing digit and advance to
System Check. To reenter mileage achieved after
a battery change, follow these steps:
When the far right digit begins to flash,
Step 1:
press Button #2 to scroll to the desired
number.
Press Button #1 to select this number
Step 2:
and advance to the next flashing digit.
Step 3: Repeat this procedure for each digit
until the correct mileage figure is
displayed (99999 = maximum). When
Button #1 is pressed to select the final
digit in the sequence, the Odometer
setting is completed and the computer
automatically advances to the System
Check screen.