Vetta V100 User Manual page 24

To stop the Service Timer icon from flashing: A) Reset the
•
accumulated Ride Time hours (upper line) to zero "0" through
the NOM Setup sequence. The Service Timer interval may also be
reprogrammed at this point. B) Change TT setting to a number
larger than accumulated RT. C) Set TT to zero "0000" (disable the
Service Timer).
The Service Timer option can be disabled in Initial or NOM
•
Setup mode by entering and selecting a value of zero "0000"
hours as the service time interval (lower line).
•
After user sets or resets the TT Service Timer interval in NOM
Setup, accumulated Ride Time digits (upper level) will start
blinking (as shown in illustration below). Press Button #2 for 2
seconds to reset RT digits to zero. Press Button #3 to exit to the
NOM System Check. Press Button #3 again to return to the
SPD/DST primary screen.
SETUP: SPEED UNITS
The icon "M/hr" will appear on the screen with
the letters "M" flashing. To select miles per hour
as the unit of speed, press Button #1. To scroll to
kilometers per hour, press Button #2 and
"KM/hr" will appear with the letters "KM"
flashing. Press Button #1 to select and
advance.