Timer Recording - JVC LPT1081-001A Instructions Manual

Timer recording

Video
DVD-RW DVD-RW DVD-RW DVD-RW
You can set the unit to record up to 8 programmes, up
to a month in advance. Daily or weekly programme
recordings are also available.
• Be sure to set the clock before entering a timer
programming.
• You can select the timer programming list by
pressing [PROG] twice. In this case, continue from
step 5.
Insert a recordable disc.
1
In stop mode, press [SET UP].
2
If you select "Advanced Setting
Menu," proceed to step 3.
If you select "Easy Setting Menu,"
proceed to step 4.
3
Select "Recording" using
[Cursor U / D], then press [ENTER].
4
Select "Timer Programming" using
[Cursor U / D], then press [ENTER].
The Timer Programming list will appear.
5
Select a programme that is not set
using [Cursor U / D], then press
[ENTER].
Timer Programming Timer Programming
Date Start
Date Start
1. - - - 1. — — —
2. - - -
3. - - -
4. - - -
5. - - -
6. - - -
7. - - -
8. - - -
6
Enter the date using [Cursor U / D],
then press [Cursor P].
Each time you press [Cursor D] at the current
date, the timer recording mode will change as
follows.
e.g., 1st January
01/01
Daily
M-F (Mon.-Fri.)
W-SAT
W-FRI
W-SUN
31/01
26
EN
VR
DVD-R DVD-R
End CH Speed
End CH Speed
7
Enter the time to start and to end
using [Cursor U / D], then press
[Cursor P].
8
Select the channel number to record
using [Cursor U / D], then press
[Cursor P].
To record from external input, select "AV1," "AV2,"
"AV3" or "AV4".
9
Select the recording speed using
[Cursor U / D], then press
[Cursor P].
(See page 20.)
10
Press [ENTER] when all information
required is entered.
Your programme setting is stored.
• To set another programme, repeat steps 5 to 10.
• To exit, press [SET UP] or [PROG].
• If the recording times of two or more
programmes overlap, "Overlap" and overlapped
programme numbers are displayed. (See pages
27 and 29.)
Timer Programming Timer Programming
Date Start End
1.
01/01 12:00 13:00
2. - - -
3. - - -
4. - - -
5. - - -
6. - - -
7. - - -
8. - - -
11
Press [STANDBY/ON y/I].
The icon will appear on the front panel display
and the unit enters to the timer-standby mode.
Note
• If you have not set the clock, the clock setting
window will appear after step 4. Continue from step
5 in "Clock Setting" on page 19 before programming
the timer.
• Press [Cursor L / P] to move the cursor in the timer
programming menu.
CH Speed
P01 XP