One-Touch Timer Recording - JVC DR-M70SEK Instructions Manual

Video VR
DVD-RW DVD-RW DVD-RW DVD-RW
This is a simple way to set the
recording time in blocks of 30
minutes. Check that the disc has
enough recordable space for the
time you set.
After finishing the recording, the
recorder automatically goes into
standby.
1
Turn on the unit and load a
recordable disc.
Make sure that the TV input is set
on the unit.
This operation may take a
while to be recognized.
2
Using [REC SPEED], select a
recording speed.
Refer to "Recording speed" on
page 26.
3
Make sure that the recording
format is set to the desired
mode.
Refer to "Formatting a disc" on
pages 28-29.
When a DVD-RW disc is
loaded:
You can choose Video mode or
VR mode from the Setting menu.
"Video mode" has been selected
as the default. Refer to page 28
"Choosing the recording format
of a blank disc."
When a DVD-R disc is loaded:
DVD-R discs will always be in
Video mode.
32
EN
Recording

One-touch Timer Recording

DVD-R DVD-R
4
Using [CH + / -] or the
Number buttons, select a
desired channel to record.
5
Press [REC I] repeatedly to
select a desired recording
time.
Recording time appears on the TV
screen (30 minutes to 4 hours).
Recording will start.
I 0:30
OFF
(Normal Recording)
4:00
When the unit reaches the speci-
fied time, it will turn off automati-
cally.
To change the recording time dur-
ing the one-touch Timer
Recording, press [REC I]
repeatedly until the desired time
appear.
To cancel the one-touch Timer
Recording within the specified
time, press [STOP C].
This operation may take a
while to be completed.
0:30
1:00
3:30
STANDBY/ON
OPEN/
CLOSE ON SCREEN SET UP
REPEAT
.@/: ABC DEF
1 2 3
ZOOM
GHI JKL MNO
4 5 6
CH
PQRS TUV W X YZ
8
7 9
CLEAR AUDIO
0
PROG
VCR Plus+
TOP MENU MENU/LIST
ENTER
RETURN
SLOW PL AY SLOW
5
REC STOP PAUSE
REC REC
SPEED MONITOR
2
Note
• The remaining recording time
will appear on the display
panel during an one-touch
Timer Recording. Press
[ON SCREEN] to see it on
the TV screen.
• You cannot pause a one-touch
Timer Recording.
• Unlike a Timer Recording, you
can perform the following
operations during a one-touch
Timer Recording.
- Turning off the power.
- Using [REC I] and
[STOP C].
• The unit will be turned off
automatically under the follow-
ing conditions.
1)No space remained on the disc.
2)When a power failure occurs.
• When OTR is finished and the
power is turned off, the unit
will switch to the standby
mode automatically if a Timer
Recording has been pro-
grammed.
Press [STANDBY/ON y y /I]
to cancel the standby mode for
using the unit continuously.
4