Digital Audio For Better Sound Quality - JVC LPT1081-001A Instructions Manual

Recording from a camcorder or other
Audio-Video equipment with no Scart output
jack (AV3 or AV4)
If no S-Video input jack is available, connect to
VIDEO input jack on the front panel using an RCA
Video cable.
Change the setup when using S-VIDEO input jack.
(See page 30.)
AV3 (Rear)
AUDIO IN
ANALOG
S-VIDEO
AUDIO OUT
(AV3)
L L DIGITAL AUDIO OUTPUT
IN
OUT (AV3)
R R
COAXIAL
S-Video
Audio cable
cable (not
(not supplied)
supplied)
S-VIDEO AUDIO
OUT OUT

Digital audio for better sound quality

Dolby Digital decoder,
DTS decoder or
MPEG decoder, etc.
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
COAXIAL
AUDIO IN ANALOG
S-VIDEO
AUDIO OUT
(AV3)
L L
DIGITAL AUDIO OUTPUT
OUT IN (AV3)
PCM/BITSTREAM
R R
COAXIAL
The connections illustrated above are
optional for better sound.
1
For clear digital sound quality, use
the DIGITAL AUDIO OUTPUT PCM/
BITSTREAM (COAXIAL) jack to
connect your digital audio
equipment.
If the audio format of the digital output does not
match the capabilities of your receiver, the
receiver will produce a strong, distorted sound or
no sound at all.
16
EN
AV4 (Front)
PR / I STANDBY/ON
_ _
S-VIDEO VIDEO
(MONO) L AUDIO R
PCM/BITSTREAM
REC SPEED
S-Video
cable (not
supplied)
S-VIDEO AUDIO
OUT OUT
Digital audio
input jack
COAXIAL
Coaxial cable
(not supplied)
Connecting a Dolby Digital™ decoder, DTS
decoder or MPEG decoder
• Connecting multi-channel Dolby Digital decoder
allows you to enjoy the 5.1ch Dolby Digital surround
system as well as DTS decoder, 5.1 channel
surround system.
• After connecting to a Dolby Digital decoder, set
"Dolby Digital" to "Stream" in the AUDIO menu. (See
page 57.)
• After connecting to a DTS decoder, set "DTS" to
"ON" in the AUDIO menu. (See page 57.)
• After connecting to a MPEG decoder, set "MPEG" to
"Stream" in the AUDIO menu. (See page 57.)
Connecting to an MD deck or DAT deck
Audio
• The audio source recorded in Dolby Digital 5.1
cable
channel surround format cannot be recorded using
(not
an MD or DAT deck as a digital sound.
supplied)
• If not connected to a Dolby Digital decoder, set
"Dolby Digital" to "PCM" in the AUDIO menu.
Playing back a DVD using incorrect settings may
generate noise distortion, and damage speakers.
• Set "Dolby Digital," and "MPEG" to "PCM" and set
"DTS" to "OFF" in the AUDIO menu for connecting
to an MD or DAT deck.
• You can use ANALOG AUDIO OUT jacks for the
connection of your audio system.
After you have completed
connections
Switch the input selector on your TV to an appropriate
external input channel. For details, refer to the
Instruction Manual of your TV.
Note
• Connect this unit directly to the TV. If the Audio/
Video cables are connected to a VCR, pictures may
be distorted due to the effects of the copy protection
system.