Panel Display - JVC LPT1081-001A Instructions Manual

Checking, cancelling, or correcting
the timer programming information
In the following example, No. 5 timer programming
overlaps on No. 1 and No. 6 timer programmes. In
such a case, you should correct the programme time
to clear the overlap.
Timer Programming
Date Start End
1. 01/01 12:00 13:00
2. - - -
3. - - -
4. - - - No.1 6
5. 01/01 12:30 14:00
6.
01/01 13:45 21:00
7. - - -
8. - - -
1
Press [STANDBY/ON y/I] so that the
icon disappears from the front

panel display.

2
Press [PROG] twice.
Timer programming list will appear.
3
Check the information on the list you
will need.
4
To clear the timer programming,
select the desired programme using
[Cursor U / D], then press [CLEAR].
To correct the timer programming
1) Select the desired programme using
[Cursor U / D], then press [ENTER].
2) Correct the timer programming using
[Cursor U / D / L / P].
3) Press [ENTER] again.
5
Press [PROG] to exit.
6
Press [STANDBY/ON y/I] to return to
the timer-standby mode.
To check the timer programming in progress
Press [PROG].
Note
• If a timer recording is proceeding, that programme is
highlighted in red. In such a case, you cannot select
any other programmes.
To stop the timer recording in
progress
Press [STOP S] on the front panel of the
unit.
Note
• [STOP S] on the remote control is not effective.
CH Speed
AV3 XP
Overlap
P02 SP
P12 SEP
If the timer programming did not
complete correctly
The error number appears on the timer programming
list.
Timer Programming Timer Programming Timer Programming
Date Start End
1. 1. 01/01 12:00 13:00
2. 2. 2. - - -
3. 3. 3. - - -
4. 4. 4. - - -
5. 5. 5. - - -
6. 6. 6. - - -
7. 7. 7. - - -
8. 8. 8. - - -
The error programme will be displayed in grey
with an asterisk and have an error number.
The error numbers indicate:
E1–E22, E37–E39: Recording error
E23–E24: Unrecordable disc
E25:•Copy prohibited programme
•Cannot record because of the NTSC / PAL-
60 signal is received.
E26–E28: Copy prohibited programme
E29: Disc protected
E30: Disc full
E31: Already recorded 99 titles (Video mode)
E32: Already recorded 99 titles (VR mode)
E33: Already recorded 999 chapters
E34: No space for Control Information
E35: PCA (Power Calibration Area) full
E36: Already finalised Video format disc
E40:•There are some unrecorded parts due the
overlapped timer programmes.
•Recording did not start at the start time.
E41: Power failure
E42: No disc
The error programme will be deleted once you
check the error in the programme list, or once you
cancel the timer-standby mode and re-enter it.
Press [CLEAR] to erase the selected
programme.
CH Speed
AV3 E1
27
EN