Installing Batteries In The Remote Control - JVC LPT1081-001A Instructions Manual

Jvc dvd video recorder instruction manual
Table of Contents

Advertisement

20 RETURN button
• Press to return to the previously displayed menu
screen.
21
(SKIP) button
B
• During playback, press to skip to the previous
chapter or track.
• When playback is paused, press to play reverse
step by step.
(SKIP) button
F
• During playback, press to skip to the next
chapter or track.
• When playback is paused, press to advance
step by step.
22 PLAY
button*
P
• Press to start or resume playback.
23 SLOW
/REV
r
• During playback, press to reverse fast.
• When playback is paused, press to reverse
slowly.
SLOW
/FWD
f
• During playback, press to forward fast.
• When playback is paused, press to forward
slowly.
24 PAUSE
button
p
• Press to pause playback or recording.
25 STOP
button*
S
• Press to stop playing back or recording.
Button names described in the Instruction
Manual
The instructions in this manual are described mainly
with the operations using the remote control. Some
operations can be carried out using the buttons on
the front panel.
button
button
Installing batteries in the remote
control
Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the polarity
indicated inside the battery compartment.
1
2
Caution
• Incorrect use of batteries can result in hazards such
as leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus and minus ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used
for a month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions
for environmental protection that apply in your
country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
About the remote control
• Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
Within about
7 m
60˚
Remote
control
• Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
• Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
• Replace the batteries when the operating range of
the remote control reduces.
3
11
EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dr-n70sek

Table of Contents