Edit From A Camcorder - JVC DR-MH30S Instructions Manual

Edit From A Camcorder

You can use a camcorder as the source player and your unit as the
recording deck.
A If the camcorder has no S-VIDEO output connector:
Recorder
Player
B If the camcorder has an S-VIDEO output connector:
Recorder
Player
AUDIO/VIDEO input
Audio/video cable
(not provided)
AUDIO/VIDEO OUT
S-VIDEO input
AUDIO input
S-video cable
(not provided)
S-VIDEO OUT
Audio cable
(not provided)
AUDIO OUT
● Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder's AUDIO/VIDEO OUT connectors to the
unit's AUDIO/VIDEO input connectors on the front panel.
● When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
B If the camcorder has an S-VIDEO output connector:
— connect the camcorder's AUDIO OUT and S-VIDEO OUT
connectors to the unit's AUDIO and S-VIDEO input connectors on
the front panel.
2
Press HDD or DVD repeatedly to select the recording deck.
3
Press PR +/– to select "F-1".
● Set "F-1 INPUT" to "VIDEO" for the VIDEO input connector, or
"S-VIDEO" for the S-VIDEO input connector, depending on the
connector being used. (
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press 7 on the unit to start recording. Or press and hold 7 and
press 4 on the remote control. The dubbing starts.
7
Press 8 on the unit, then stop playback on the camcorder.
NOTES:
● All necessary cables can be obtained from your dealer.
● Refer to the camcorder's instruction manual for operating procedure.
● The quality of dubbed picture becomes poorer than that of the
original.
EDITING
pg. 62)
59
EN