Installing The Main Landing Gear; Installing The Tail - HobbyZone HBZ7600 Glasair Sportsman Instruction Manual

6
Installing the Main
Landing Gear
The nose gear is installed at the factory. Always
ensure the steering linkage clevis on the rudder servo
arm is correctly adjusted so the nose steers straight
when the rudder control is at neutral.
1. Turn the model so you can see the bottom of
the fuselage.
- Install the left and right fairings (A) on the respective
sides of the landing gear strut as shown.
- Install the main landing gear by inserting the main
gear strut (B) into the slot in the fuselage as shown.
2. Install the left and right plates (C) on the fuselage
using 4 screws (D) as shown.
Disassemble in reverse order.

Installing the Tail

To install the tail onto the fuselage of your aircraft, start
by following the 2 easy steps below:
1. Insert the tail into the slot on the fuselage. Center it by
using the centering guides (A) located on the top side
of the tail.
2. Once the tail is in place and centered, apply 4 pieces
of tape (included) to secure it into position, 2 on
top and 2 on the bottom (B).
Attaching the Clevis to the
Control Horn.
Finish the installation of the tail by connecting the control
rod with the clevis on the tail control horn under the
elevator.
1. Open the clevis and put the pin in the second from
the outermost hole (A) of the control horn.
2. If needed, remove the clevis from the control horn.
- Turn the clevis (as shown) on the control rod (also
called a pushrod).
- Close the clevis onto the control horn and slide the
tube towards the horn to secure the clevis.
Glasair Sportsman
EN
1
B
1
A
1
Clevis
A
2
C
A
2
B
2
Control
Horn
D