Control Direction Test - HobbyZone HBZ7600 Glasair Sportsman Instruction Manual

10

Control Direction Test

IMPORTANT: Perform the Control Direction Test before
activating Virtual Instructor (advancing the throttle above
25% for the fi rst time).
1. Power on the transmitter.
2. Make sure the throttle is at 0% and the throttle trim is
fully lowered on the transmitter.
3. Power on the model.
Make sure the control surfaces (rudder, elevator and
ailerons) are at neutral or 0 degrees. Ideally, centering the
trim will center the surfaces. Refer to the Control Center-
ing instructions to adjust the control surfaces. Move the
transmitter control sticks so the model's rudder, elevator
and ailerons move as shown.
If your model does not respond correctly, DO NOT FLY!
See the Troubleshooting Guide in this manual for more
information. If you need more assistance, contact the ap-
propriate Horizon Product Support department.
The mode of the included transmitter cannot be changed
between Modes 2 and 1.
Tip: To determine what mode your transmitter is, look at
the Trainer/Bind button. When looking from the front, the
Mode 2 transmitter's Bind button is on the left, while the
Mode 1 transmitter's Bind button is on the right.
Glasair Sportsman
EN
Transmitter command
Mode 1 Mode 2
Up Elevator
Command
Down Elevator
Command
Stick Right
Stick Left
Stick Right
Stick Left
Control Surface Reaction