PREPARATION FOR USE
2-50.
FINAL INSTALLATION
In an iSBC single board computer based system, install the iSBC 86/14/30
board in any card slot that has not been wired for a dedicated function.
In an Intellec System, install the iSBC 86/14/30 board in any slot except
slot 1 or 2.
Ensure that auxiliary edge connector P2 (if used) is
correctly installed.
Attach the appropriate cable assemblies to parallel
and serial connectors J1 and J2 and install any required Multimodule
boards and their interfacing connectors at Multimodule connectors J3 and
J4.
CAUTION
Always turn off the computer system
power supply before installing or
removing the iSBC 86/14/30 board and
before installing or removing interface
cables.
Failure to take these
precautions can result in damage to the
iSBC 86/14/30 board.
2-81