Daewoo DWC-LU1011 Service Manual page 46

6. Error Display
MESSAGE ERROR CAUSE
The water tap is closed.
The filter of the valve inlet is clogged.
The valve inlet is an inferior product or broke down. Change the valve inlet.
WATER
IE
The water level sensor (sensor pressure) is an
INLET ERROR
inferior product or broke down.
The drain motor works during water supply.
The PCB ASS'Y does not check the water level.
The drain hose is kinked or clogged.
The drain motor is an inferior product.
DRAIN
OE ERROR The valve inlet works during drain.
The water level sensor is an inferior product .
The PCB ASS'Y does not check the water level.
UN-BALANCE The laundry is concentrated to one side of the drum
UE ERROR during spin.
The Start/Hold button is pressed while the door is
opened.
DOOR
LE
OPEN ERROR The switch door lock is an inferior product.
The PCB ASS'Y does not check the door lock.
Water level Water level is below reset or overflow is detected
E1
detection error
The water is supplied continuously due to an inferior
valve inlet.
OVER
The valve inlet is normal, but the water level sensor
E2 FLOW ERROR
(sensor pressure) is inferior.
The drain motor dose not work.
(The fan motor is an inferior product or broke down.)
The fan motor does not work.
(The fan motor is an inferior product or broke down.)
FAN MOTOR
E3
ERROR
The PCB ASS'Y does not control the fan motor.
Water leaks from the tub or the hose drain.
LEAKAGE
E4
ERROR
The foreign matter is jammed in the drain bellows.
(Non-pump model)
The laundry is jammed between the gasket and the
HIGH
drum.
E5 VOLTAGE
ERROR
The PCB ASS'Y is an inferior product.
The laundry is jammed between the gasket and the
drum.
E6 EMG ERROR
The motor is an inferior product.
The PCB ASS'Y is an inferior product.
SOLUTION
Open the water tap.
Clean the filter of the valve inlet.
Change the water level sensor
(sensor pressure).
Change the drain motor.
Change the PCB ASS'Y.
Clean and straighten the drain hose.
Change the drain motor.
Change the valve inlet
Change the water level sensor.
Change the PCB ASS'Y.
Rearrange the laundry.
Close the door.
Change the switch door lock.
Change the PCB ASS'Y.
Change the sensor pressure.
Change the valve inlet.
Change the water level sensor
(sensor pressure).
Change the drain motor.
Change the fan motor.
Check the connector or change the
PCB ASS'Y .
Check the leak of the tub or the hose
drain. Then change the tub or the
hose drain.
Remove the foreign matter in the
drain bellows.
Rearrange the laundry.
Change the PCB ASS'Y.
Rearrange the laundry.
Change the motor.
Change the PCB ASS'Y.
44 44