Fixing A Document Jam; Cleaning; Power Cycling - BELGACOM Belgafax 802 User Manual

3 Carefully pull out the paper.
EN
In case of a paper jam, do not forcefully remove
the paper, but rather pull it gently out of the de-
vice and throw it away carefully. It is possible that
the toner may not be completely set on the print-
out, and toner dust could be released into the air.
Do not inhale the released toner dust. Remove
the toner dust from clothing or objects with cold
water; hot water would only cause the toner to
set.
4 Reinsert the toner cartridge and close the cover. Make
sure that the cover snaps securely into position on both
sides.
If the toner level of the cartridge is low, then every
time you open and close the cover, the following
question
BLACK=NEW? . If you have not installed a new
cartridge, press j. Whenever you have installed
a new toner cartridge, press OK, and update the
toner level memory (also see chapter Changing
the Toner Cartridge, page 30).

Fixing a Document Jam

Introduction
If a document jam should occur in the front area:
1 Lift the panel upwards until it snaps into position.
2 Carefully pull the paper or document forwards until it
is released.
3 Close the panel.
32
will appears on the

Cleaning

Cleaning
Unplug the device from the power socket before
cleaning it. Use a soft, lint-free cloth. Never use liq-
uid or easily flammable cleansers (sprays, abrasives,
polishes, alcohol, etc.). Do not allow any moisture to
reach the interior of the device.
1 Lift the panel upwards until it snaps into position.
2 Wipe the scanner glass with a soft, dry and lint-free
cloth behind the rollers for the paper guide.
3 Close the panel.

Power Cycling

If a problem occurs that cannot be corrected with the in-
structions in this user manual (see also the help below), fol-
low the steps given here.
1 Pull out the power plug.
display:
2 Wait at least ten seconds, then plug the power plug
back into the socket.
3 If the error occurs again, please contact Belgacom.
Belgacom Belgafax 802