Table of Contents
Advertisement
14
2 SEC
STARTUP
ON
DIAGNOSTIC
If the system is not functioning correctly, apply the steps below. If the system still does not work correctly, please take the bicycle to an Authorized
Specialized Dealer.
Restart system
Go ride
The BMS of the battery automatically checks the functionality of the system. If the system detects an error, the corresponding error message is
displayed on the screen.
If you receive such an error, please restart the system. If the error message continues to be shown, please contact your Authorized Specialized Dealer
for further instructions. Depending on the type of error message, the system may be switched off automatically. It is possible to continue riding with
this system switched off without support from the motor, at any time.
Message displayed
Meaning
The battery is too hot
The battery is too cold
Battery damaged
Battery is in protection mode
Short-circuit
Battery management is not
communicating with the components
Low battery
Motor overheating
Motor very warm; danger of overheating
Motor damaged
Remote damaged
Please only allow an Authorized Specialized Dealer to carry out all checks and repairs. If the error continues to be displayed despite
attempted solutions, contact an Authorized Specialized Dealer.
MOTOR OK
BATTERY OK
Make sure battery is off
Take out battery
Turn on, wait 5 sec, turn off again
Install in bicycle
Restart system
F. Error codes displayed
Solution
Please pull over and turn off the system. Allow the system to cool down for long enough that
the error message is no longer displayed. It is also possible to continue riding without battery
support, which aids the system's cooling process
Allow the system to warm up at room temperature for long enough that the error
message is no longer displayed
Please contact your Authorized Specialized Dealer immediately
Restart the system. If the error continues to be displayed, contact an Authorized
Specialized Dealer
Please contact your Authorized Specialized Dealer immediately
Restart the system. Check the connections
Connect the battery to the charger and plug into a power source to charge the battery
Please pull over and turn off the system. Allow the system to cool down for long enough that
the error message is no longer displayed. It is also possible to continue riding without battery
support, which aids the system's cooling process. Do not touch the motor! Danger of burns!
Reduce speed. Only ride in eco mode. Do not touch the motor! Danger of burns!
Please contact your Authorized Specialized Dealer
Please contact your Authorized Specialized Dealer
LIGHT OK
REMOTE OK
Take bicycle to an Authorized
Specialized Dealer
Go ride
X2
ANY LED BLINK x2:
• Connection failed
• Component can't
OFF
be found
19
Hide quick links:
Advertisement
Table of Contents
