Table of Contents
Advertisement
SYSTEM CONNECTIONS
70
EN
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
Dolby Digital Decoder or
amplifier with built-in DTS
(not supplied)
To [DIGITAL AUDIO
OUT (COAXIAL)]
Note for connection:
Remove the protection cap from the optical cable.
1
Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
●
For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY
DIGITAL/PCMB. (A pg. 71)
●
For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB.
(A pg. 71)
CAUTIONS:
●
This unit has a dynamic range of more than 110 dB with regards
to its Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to
the speakers may damage them.
●
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely
affect the playback picture.
To DIGITAL AUDIO input
Coaxial cable
Optical cable
(not supplied)
To [DIGITAL AUDIO
OUT (OPTICAL)]
Rear of unit
When you can't switch the audio channel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional optical cable and ADIGITAL AUDIO OUTB is set to ADOLBY
DIGITAL/PCMB, it is not possible to switch the audio channel of a
bilingual programme recorded on a DVD-RAM or DVD-RW (VR
mode) disc. In this case, perform the following steps using the
remote control to switch ADIGITAL AUDIO OUTB from ADOLBY
DIGITAL/PCMB to APCM ONLYB.
A Press SET UP to access the Main Menu screen.
B Press selection keys to select ADVD VIDEO SET UPB, then
press G.
C Press selection keys to select AAUDIO OUTPUTB, then press
G.
D Press selection keys to select ADIGITAL AUDIO OUTB, then
press ENTER.
E Press selection keys to select APCM ONLYB, then press
ENTER. (A pg. 71)
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel.
Connecting/Using A Decoder
The [L-2 IN/DECODER] connector can be used as an input
connector for an external decoder (descrambler). Simply connect a
decoder and you can enjoy a variety of programming that is
available through scrambled channels.
Decoder
TV
1
Set AL-2 SELECTB to ADECODERB. (A pg. 63)
2
Connect your unit's [L-2 IN/DECODER] connector to the
decoder's 21-pin SCART connector using a 21-pin SCART
cable.
3
Perform the procedure as described in AWhen Receiving A
Scrambled Broadcast (HDD & DVD Deck Only)B (A pg. 76).
TV aerial cable
[L-1 IN/OUT]
[L-2 IN/
DECODER]
RF cable (supplied)
Advertisement
Table of Contents
