Connecting To A Dolby Digital Decoder Or An Amplifier With Built-In Dts; Connecting/Using A Decoder - JVC DR-MV1 Instructions Manual

Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby
Digital decoder or an amplifier with built-in DTS.
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not supplied)
DIGITAL AUDIO OUT (COAXIAL)
2
Note for connection:
Remove the protection cap from the cable.
1
Connect the unit and a Dolby Digital decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
● For Dolby Digital sound, set "DIGITAL AUDIO OUT" to "DOLBY
DIGITAL/PCM". ( pg. 78)
● For DTS sound, set "DIGITAL AUDIO OUT" to "STREAM/PCM".
( pg. 78)
CAUTIONS:
● This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
● Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
Downloaded From DvDPlayer-Manual.com JVC Manuals
Optical cable
(not supplied)
DIGITAL AUDIO OUT (OPTICAL)
When you can't switch the audio chaonnel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional optical cable and "DIGITAL AUDIO OUT" is set to "DOLBY
DIGITAL/PCM", it is not possible to switch the audio channel of a
bilingual programme recorded on a DVD-RAM or DVD-RW (VR
mode) disc. In this case, perform the following steps using the
remote control to switch "DIGITAL AUDIO OUT" from "DOLBY
DIGITAL/PCM" to "PCM ONLY".
A Press SET UP to access the Main Menu screen.
B Press w e to select "DVD SET UP", then press ENTER.
C Press w e to select "AUDIO OUTPUT", then press ENTER.
D Press rt to select "DIGITAL AUDIO OUT", then press
ENTER.
E Press rt to select "PCM ONLY", then press ENTER.
( pg. 78)
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel. (

Connecting/Using A Decoder

The L-2 IN/DECODER connector can be used as an input
connector for an external decoder (descrambler). Simply connect a
decoder and you can enjoy a variety of programming that is
available through scrambled channels.
Decoder
L-1 IN/OUT
TV
1
Set "L-2 SELECT" to "DECODER". (
2
Connect your unit's L-2 IN/DECODER connector to the
decoder's 21-pin SCART connector using a 21-pin SCART cable.
3
Perform the procedure as described in "When Receiving A
Scrambled Broadcast" ( pg. 84).
SYSTEM CONNECTION
77
EN
pg. 28)
TV aerial cable
L-2 IN/DECODER
RF cable
(provided)
pg. 72)