Installation The Speed & Cadence Sensor - Specialized SpeedZone User Manual

INSTALLING THE SPEED & CADENCE SENSOR
SPEEDZONE COMP - WIRELESS SPEED SENSOR
INSTALLATION
1. Pass the two cable ties through the sensor mounting holes and loosely mount to the left fork
leg using the rubber sensor mounting pad (do not fully tighten the cable ties at this point). The
sensor should be mounted as close to the top of the fork as possible with the cap of the battery
door toward the ground. Make sure that the distance between the sensor and the handlebars is
no more than 24 in. (610mm).
2. Loosely install the sensor magnet to one of the spokes of the front wheel. Adjust the position
of the magnet and sensor together so that the magnet is aligned with the line on the bottom
edge of the sensor and 1-2 mm separates the two parts and tighten both parts in place. DO NOT
over-tighten the magnet screw.
10
INSTALLING THE SPEED & CADENCE SENSOR
SPEEDZONE COMP - WIRED REAR CADENCE HARNESS
(CADENCE HARNESS AVAILABLE SEPARATELY)
1. Attach the cadence sensor to the LEFT chain stay near where the crank/pedal pass the
����������
stay using the zip-ties provided. Do not fully tighten zip-ties. (see illustration on page 8)
NOTE: The wires exiting the sensors should be pointing toward the front of the bike.
2. Attach the cadence magnet to the back side of the LEFT crank arm using the zip-tie
provided.
3.
Align the cadence sensor and magnet and rotate the sensor so the magnet passes within
1-3mm.
4. Route the sensor wire forward and under the bottom bracket and along the bottom of the
down tube securing it occasionally with tape. Once you are near the head tube the sensor
wire should be wrapped around the front or rear derailleur cable housing and the around
the front brake cable housing.
CAUTION: Make sure you leave enough slack in the sensor wire so the handle bars can turn
fully from side to side.
5. Attach the bracket to the handlebars or stem.
������
11