Table of Contents
Advertisement
2.8 Park (Applies to 3960
Privileged User and Administrator are allowed to establish the
park position.
Cameras can be set to automatically move to a preset or start a
tour after a selected interval of inactivity.
The time can be programmed in seconds, minutes, or hours.
2.9. Auxiliary
Privileged User and Administrator are allowed to configure the auxiliary control function.
This control allows a user to program wiper functions, to display temper-
ature and pressure inside the barrel or dome, and to send the camera
system to the home position.
NOTE:
•
Guest cannot turn the wiper on.
•
User can turn the wiper on.
Wiper (Applies to 3960
HD
Run Time: Type the desired wiper run time. The time can be set from 1 to
9999 seconds (2.77 hours). The run time is total duration that the wiper
will be active.
Dwell Time: Type time between cycles. A cycle is 2-3 wipes. The time
can be set from 0 to 99 seconds (1.65 minutes).
Set Times: Click the button to send settings to the camera.
Wiper: Check the button to start the wiper.
Aux Control (Applies to 8800
Auxiliary control activates a device, such as a relay.
Momentary mode:
•
Click the Momentary button.
•
Type the time in seconds in the box.
•
Click the Output button. The device will stay active for the pro-
grammed amount of time.
•
Click the Output button again to deactivate the device.
Latched mode:
•
Click the Latched button.
•
Click the Output button. The device will stay active for the desired amount of time.
•
Click the Output button again to deactivate the device.
Heater Function (Applies to 8800
•
Click the Enable button to activate the heater.
Seek Pan/Tilt Home (Applies to 3960
Home position is the returning position and serves as the resting position for both pan and tilt.
•
Seek Pan/Tilt Home: Recalibrates the pan/tilt stepper position.
6X-1090J
/3920
/3720
/3120
)
HD
HD
HD
HD
/3960
/3930
/8800
)
SD
HD
HD
)
HD
)
HD
/3960
/3920
HD
SD
/3920
/3720
/5970
/8800
HD
SD
HD
SD
/3120
)
HD
HD
47
Advertisement
Table of Contents
