Table of Contents
Advertisement
Problem
The PC Camera module cannot be
detected.
The Wireless LAN/PC Camera/3.5G
modules cannot be configured.
A file cannot be copied to/from a
connected Bluetooth device.
The Bluetooth module is off after
resuming from Sleep.
Possible Cause - Solution
The module is off. Press the Fn + F10 key combination in order to enable the
module (see
"Function/Hot Key Indicators" on page 1 -
BisonCap program to view the camera picture.
The driver(s) for the module(s) have not been installed. Make sure you have
installed the driver for the appropriate module (see the instructions for the
appropriate module in
"Modules & Options" on page 7 - 1/"Module Drivers"
on page E -
37).
The transfer of data between the computer and a Bluetooth enabled device is
supported in one direction only (simultaneous data transfer is not
supported). If you are copying a file from your computer to a Bluetooth enabled
device, you will not be able to copy a file from the Bluetooth enabled device to
your computer until the file transfer process from the computer has been
completed
The Bluetooth module's default state will be off after resuming from the Sleep
power-saving state. Use the key combination (Fn + F12) to power on the
Bluetooth module after the computer resumes from Sleep.
Problems and Possible Solutions 8 - 11
Troubleshooting
12). Run the
8
Advertisement
Table of Contents
