Table of Contents
Advertisement
Upgrading The Computer
Figure 6 - 10
RAM Module
Removal
Single Memory
6
Module Installation
If your computer has a
single memory module,
then insert the module
into
the
Channel
(JDIMM1) socket. In this
case this is the lower
memory socket (the
socket closest to the
mainboard).
6 - 10 Upgrading the System Memory (RAM)
6.
The RAM module will
7.
Pull the latches to release the second module if necessary.
0
8.
Insert a new module holding it at about a 30° angle and fit the connectors firmly
into the memory socket (see sidebar note if you are inserting a single module).
9.
The module's pin alignment will allow it to only fit one way. Make sure the module
is seated as far into the slot as it will go. DO NOT FORCE the module; it should fit
without much pressure.
10. Press the module in and down towards the mainboard until the slot levers click into
place to secure the module.
11. Replace the bay cover and screws (make sure you reconnect the fan cable
before screwing down the bay cover).
12. Restart the computer to allow the BIOS to register the new memory configuration
as it starts up.
pop-up, and you can remove it.
8
8
Advertisement
Table of Contents
