Other Trouble Displays - ADEMCO VISTA-10SEa User Manual

TROUBLE CONDITIONS (cont)

Other Trouble Displays

Words or letters in parentheses (
word keypads.
1. COMM. Indicates that a failure has occurred in the telephone communication
FAILURE
portion of your system. CALL FOR SERVICE IMMEDIATELY.
(or FC)
2. SYSTEM LO Indicates that a low system battery condition exists, and is accompanied by
BAT (or BAT
a once-per-minute beeping* at the keypad. If this condition persists for more
with no zone
than one day (with AC present), CALL FOR SERVICE.
no.)
3. LO BAT + Indicates that a low-battery condition exists in the wireless transmitter**
zone
number displayed, and is accompanied by a once-per-minute beeping* at the
descriptor
keypad. Either replace the battery yourself, or CALL FOR SERVICE. If the
(or BAT with
battery is not replaced within 30 days, "CHECK" display may occur.
zone no.)
Some wireless sensors contain a nonreplaceable long-life battery that
requires replacement of the entire unit at the end of battery life (e.g., 5802
Pendant and 5802CP Belt Clip Personal Emergency Transmitters).
4. MODEM Indicates that the control is on-line with the central station's remote
COMM
computer. The control will not operate while on-line. Wait a few minutes.
(or CC)
The display should disappear.
5. AC LOSS The system is operating on battery power only, due to a mains failure. If
(or NO AC)
only some lights are out on the premises, check circuit breakers and fuses,
and reset or replace as necessary. CALL FOR SERVICE if mains power
cannot be restored to the system.
6. BUSY If this remains displayed for more than 1 minute, system is disabled. CALL
STANDBY
FOR SERVICE IMMEDIATELY.
(or dI)
7. OPEN The keypad is not receiving signals from the control.
CIRCUIT
(or OC)
* Any beeping that accompanies a trouble display can be stopped by entering an OFF
sequence (code + OFF).
** Not all systems use wireless transmitters.
– 30 –
) are those that are displayed on fixed-