Preparing Hot Water - Nespresso Magimix D-150 User Manual

Plug in the machine.
Fill the water tank (1) (2) (3).
Insert the empty capsule holder in the spout
ring by turning it from left to right. Once in
place, the handle should appear straight in
front of you or slightly to the right (5).
Place a sufficiently large container under the
capsule holder and a second one under the
steam / hot water nozzle (6). The function
knob should be on the «0» position.
Turn on your machine by pressing the On/Off
(7). The steam / hot water switch
Switch to
should be on the position. Both the red
function control light and the yellow tempera-
ture control light will go on (7).
Once the yellow temperature control light
goes off, your machine is warmed up and
ready for use.
Turn the function knob to the
the right and let approximately half of the
water in the tank run through (8). Return the
function knob to the «0» position.
Turn the function knob to the
left and let the rest of the water in the tank run
through to rinse the steam / hot water circuit
(9). Return the function knob to the «0» position.
Preparing a espresso
(10-14)
To obtain optimal coffee quality, preheat the
machine daily with the empty capsule holder
and rinse the system before making the first and
after the last espresso of the day. Do this by tur-
ning the function knob to the
right for about 5 seconds.
position on
position on the
This machine equally allows you to prepare hot
position on the
water for tea, instant coffee or soup.
Fill the water tank with fresh water (1) (2) (3).
Insert the capsule holder in the spout ring in
order to preheat it.
Verify that the function knob is on the «0»
position (10).
Turn on your machine by pressing the
(10). Both the red light
On/Off Switch to
and the yellow control light will go on.
Once the yellow temperature control light
goes off, your machine is warmed up and
ready for use.
Remove the capsule holder from the spout
ring and insert a capsule with the largest part
towards the base (11).
Reinsert the capsule holder in the spout ring
by turning it from left to right until the handle
appears straight in front of you or slightly to
the right (12).
Place a preheated cup under the capsule hol-
der (see the section on "Preheating Cups").
Turn the function knob to the
the right (13).
Once your espresso is prepared, return the
function knob to the «0» position. Remove the
capsule holder from the spout ring and dis-
card the used capsule (14).
To ensure that your next espresso will be pre-
pared at optimal temperature, reinsert the
capsule holder in the spout ring and turn it
from left to right.

Preparing Hot Water (15)

position on