Mitsubishi 4G1 Service Manual page 84

11 B-22
silent shaft sprocket with the marks on the front case
respectively.
(2) Install the timing belt "B" on the crankshaft sprocket "B"
and silent shaft sprocket. There should be no slack on the
tension side.
(3) Make sure that the relationship between the tensioner
pulley center and the bolt center' is as shown in the
illustration.
(4) Move the tensioner "B" in the direction of arrow while
lifting with a finger to give a sufficient tension to the tension
side of timing belt. In this condition, tighten the bolt to
secure tensioner "B". When the bolt is tightened, use care
to prevent the shaft from turning together. If the shaft is
turned together, the belt will be overtensioned.
(5) Check to ensure that the timing marks on the sprockets and
front case are in alignment.
(6) Press with index finger the center of span on the tension
side of timing belt "B". The belt must deflect 5 to 7 mm
CRANKSHAFT BOLT TIGHTEifING
(2) Install the crankshaft bolt.
TSB Revision