Mitsubishi 4G1 Service Manual page 176

11 C-52
Red cl
Blue
DISASSEMBLY SERVICE POINTS
THROTTLE POSITION SENSOR AND IDLE AIR/
SPEED CONTROL MOTOR REMOVAL
(1) Do not disassemble the sensor and motor.
(2) Do not immerse the sensor and motor in cleaning solvent.
Clean them with shop towel.
THROTTLE BODY REMOVAL
(1) Do not remove the throttle valve.
(2) Check if the vacuum port or passage is clogged. Use
compressed air to clean the vacuum passage.
Operational Check
connector.
(2) Connect the positive 0 terminal of 6 volt battery to white
clip and green clip of Test Harness.
TSB Revision