Mitsubishi 4G1 Service Manual page 454

(6) Install the timing belt on the crankshaft sprocket, idler
pulley, camshaft sprocket, and tensioner pulley in that
order.
(7) Lift up the tensioner pulley in the direction of arrow and
tighten the center bolt.
(8) Check to see that all timing marks are lined up.
(9) Remove the screwdriver inserted in step (5) and fit the plug.
turn it clockwise until the timing marks are lined up again.
Wrench, on the tensioner pulley, and loosen the tensioner
pulley center bolt.
NOTE
If the special tool is not available, use a commercially
available torque wrench that is capable of measuring 0 - 3
Nm (0 - 2.2 ft.lbs.).
wrench.
torque wrench, tighten the center bolt to specification.
alone for approx. 15 minutes. Then, make sure that the auto
tensioner setting wire moves freely.
NOTE
If the wire does not move freely, repeat step (10) above
until it moves freely.
auto tensioner body).
Standard value: 3.8 - 4.5 mm (.I5 - .18 in.)
1