Mitsubishi 4G1 Service Manual page 395

Base
A
Pin depth set
CRANKSHAFT PIN OIL CLEARANCE
METHOD)
The crankshaft oil clearance can be measured easily by using a
plastic gauge, as follows:
the crankshaft pin and the bearing inner surface.
(2) Install the crankshaft.
(3) Cut the plastic gauge to the same length as the width of the
bearing and place it on the pin in parallel with its axis.
(4) Gently place the crankshaft bearing cap over it and tighten
the bolts to the specified torque.
(5) Remove the bolts and gently remove the crankshaft bearing
cap.
(6) Measure the width of the smashed plastic gauge at its
widest section by using a scale printed on the plastic gauge
bag.
Standard value: 0.02 - 0.05 mm (.OOOS - .0020
Limit: 0.1 mm (.004 in.)
INSTALLATION SERVICE POINTS
PISTON PIN INSTALLATION
Fit the correct piston support on the top of the base. Inset-t
the press pin, threaded end up, into the hole in the piston
Press Pin
support until the press pin touches the stop screw.
(2) Using the graduations on the press pin, adjust the stop
screw to the depth.
Piston
Depth: MONTERO and TRUCK
Revision
TSB
DIAMANTE, 3000GT
1
(PLASTIC GAUGE
60 mm
62 mm