Mitsubishi 4G1 Service Manual page 457

Wrench, on the tensioner pulley, and loosen the tensioner
pulley center bolt.
NOTE
If the special tool is not available, use a commercially
available torque wrench that is capable of measuring 0 - 3
Nm (0 - 2.2 ft.lbs.).
wrench.
torque wrench, tighten the center bolt to specification.
alone for approx. 15 minutes. Then, make sure that the auto
tensioner setting wire moves freely.
NOTE
If the wire does not move freely, repeat step (13) above
until it moves freely.
auto tensioner body).
Standard value: 3.8 - 4.5 mm (.15 - .18 in.)
TSB Revision