Product Installation And Operation; Installing The Pinpoint Gps Modules - MotorGuide Pinpoint User Manual

PRODUCT INSTALLATION AND OPERATION

Installing the Pinpoint GPS Modules

Before working around electrical system components, disconnect the battery
cables from the battery to prevent injury or damage to the electrical system due to
an accidental short circuit.
1. Starting with the negative (–) lead, disconnect the trolling motor battery cables
from the battery, or unplug the trolling motor from the boat's power receptacle.
2. Remove the five screws from under the trolling motor head. Remove the cover
from the trolling motor head.
3. Remove the cable grommet from the trolling motor head.
a a
4. Place the upper GPS module into the trolling motor head as shown, with the
GPS cable exiting the module from below. Secure the upper GPS module to the
trolling motor head with two mounting screws. Push the power wires to one side
to ease installation of the GPS cable. Route the GPS cable out of the trolling
motor head, through the slot in the cable grommet as shown.
NOTE: The cable grommet is molded to allow the GPS cable to be routed under it.
eng
!
Screw locations—under trolling motor head
WARNING
52749
a -
b
b -
54435
3
GPS module mounting
holes
Cable grommet