Storing And Overwriting A Route; Recalling A Stored Route - MotorGuide Pinpoint User Manual

PRODUCT INSTALLATION AND OPERATION

Storing and Overwriting a Route

A route can be stored from any mode by pressing the route record button. The
trolling motor will emit a tune when the route record button is pressed. Once the
route record button is pressed, begin navigating along your desired course. You can
switch between manual mode and heading lock mode at any time while recording a
route. The trolling motor will emit one beep (and the GPS status indicator light will
blink) for every 2 m (6.5 ft) traveled while recording. Press and hold any of the
numbered memory buttons to stop recording and store the route to the selected
memory button. The trolling motor will emit a tune to confirm that it has stored the
route. The trolling motor can store up to eight routes, each up to 6.4 km (4 miles) in
length.
Overwriting a stored route is accomplished using the same procedure as storing a
new route.

Recalling a Stored Route

A stored route can be recalled while operating in any mode by pressing the route
playback button, then pressing the desired memory button. The trolling motor will
emit an ascending chirp to indicate that the route has been successfully recalled.
IMPORTANT: When recalling a stored route, the system will calculate a straight‑line
course from your current position to the nearest point on the recalled route. Ensure
that there are no obstructions to navigation between your current position and the
recalled route. The system will recall a stored route even if obstructions are present.
If obstructions are encountered, navigate around them by operating in manual mode.
20
eng