Yeti Cycles 575 Owner's Manual page 12

Assembly
linkaGe assemblY Slide a washer, press-cup, and press-cup insert
1
onto the threaded bolt.
linkaGe assemblY Place two of the Dogbone bearings and the
2
1.38" steel pin onto the threaded bolt as shown followed by a washer
and nut.
linkaGe assemblY The procedure in step two produces a relief,
3
shown on the right, that aids in the assembly.
linkaGe assemblY Slide one of the black nylon washers onto the
4
steel pin flush against the inside edge of the bearings.
assemblY 24
threaD PreP Yeti recommends prepping all threads with
Loctite or grease. The medium strength (blue) formula along
with proper torque is ideal for keep the bolts snug.
linkaGe assemblY Place the Dogbone over the shock with the
5
counter-bored holes facing the lever of the shock, and the threaded
end of the hold facing away from the shock. Slide the pin sub assembly into
the shock eyelet as shown.
linkaGe assemblY Once you have the pin subassembly started
6
into the shock eyelet, you can slide the threaded bolt, press-cup,
and press-cup insert configuration from step 1 through the steel pin
subassembly and shock. On the opposing end of the bolt slide the second
nylon washer, remaining two bearings, press-cup insert, press-cup,
washer, and nut.
linkaGe assemblY Take a 1/2" and adjustable wrenches and torque
7
the linkage together until the bearings press into position.
linkaGe assemblY Insert the small socket head cap screws into
8
the Dogbone, and torque down with a 2.5mm allen key
Torque spec: 125-150 inch pounds.