Configuration - Micronics D5CUB PCI Manual

4
After the D5CUB system board and all hardware is
installed, the system is ready for configuration. Before
turning on the computer, make sure all cables are cor-
rectly connected and all jumpers are correctly set.
We recommend that you keep the computer cover off
the first time you boot the system. This makes it faster
and easier to correct any difficulties that might arise.
Power up the D5CUB. If the system does not properly
boot, check all your cables and peripherals for bad
connections. You may also get beep codes or error
messages. If this occurs, consult Appendix B for a guide
to possible solutions.
After the system properly boots, it is ready to be config-
ured. The following information explains the proper
procedures for BIOS configuration.
The Setup program is used to configure the computer's
BIOS (Basic Input/Output System). The computer's
BIOS is responsible for configuring the system board and
providing hardware information to the operating system.
In order for the computer to run properly, run the Setup
procedure after first installing the system board and
whenever you make a hardware change to the system.