Tools Required - Micronics D5CUB PCI Manual

Installation of the D5CUB system board depends on the
type of case you use. The D5CUB is an integrated baby AT
size system board and may be installed into most cases.
NOTE: If you are unfamiliar with installing a system board,
Micronics highly recommends that you read the computer
user's manual or contact your dealer's technical support
department.

Tools Required

Micronics recommends using the following tools to install
the D5CUB:
Small Phillips screwdriver
Tweezers or a pair of needle-nose pliers
Tray (to hold loose screws)
Equipment Required
Micronics recommends using the following equipment
with the D5CUB for a typical configuration:
Chassis with standard hardware.
A high quality power supply capable of providing
continuous power within a 5 volt range.
PS/2 mouse and standard AT style keyboard.
Eight ohm speaker.
Standard ribbon cables for internal connections.
Standard power cord (grounded).
Heat sink with cooling fan for CPU (required).