Figure 8-43.Holding Ce-Ucm Flex; Figure 8-44.Reassemble Flexes - Motorola Astro XTS 4000 Service Manual

Disassembly/Reassembly Procedures: Radio Reassembly
18. While holding the CE-UCM Flex as shown in
rotate the Main Board (29) towards the chassis and into position by aligning the board to the
two chassis alignment pins. Check to make sure the battery B-plus seal is not pinched.
19. Plug the CE-UCM Connector Flex (28) to the Main Board (29).
8.7.4 Assemble the Chassis Assembly to the Flip-Front Housing Assembly
To assemble the chassis sub assembly (C) and Flip-Front Housing Assembly (A+B):
1. Place the Flip-Front Housing Assembly and chassis assembly side by side with the chassis
on the right. Plug in the connector of the Keypad Backer Inner Jumper Flex (17) to the Main
Board (29) top side. Also plug in the connector on the CE-UCM Connector Flex (28) to the
UCM Board (10) located at the bottom of the Flip-Front Housing Assembly as shown in
Figure
Chassis alignment
feature
Figure 8–43. Holding CE-UCM Flex
8–44.
Figure 8–44. Reassemble Flexes
Figure 8–43 so as to clear the Main Board,
8-29