Figure 8-30.Reassemble Flip Flex; Figure 8-31.Assemble T6 Screws To Front Housing - Motorola Astro XTS 4000 Service Manual

8-22
10. Prepare the surface of the Keypad Backer Sub-Assembly (15) as discussed in the first
caution note of
connector area of the Flip Flex (2). While holding the Front Housing Assembly (B) in one
hand and the Keypad Backer Assembly in the other as shown in
connector of the Flip Flex to the Keypad Backer Sub-Assembly. Press fit the whole flex
surface especially the perimeter for 10 seconds.
NOTE: Prior to reassembling the Speaker Compartment and Main Seals, inspect the seals and
sealing surfaces for damage (nicks, cuts, etc.) or dirt.
11. Assemble the Speaker Compartment Seal (13) to the Keypad Backer Sub-Assembly (15).
Ensure the seal alignment tabs are properly located and fully seated.
12. With the Flip-Front Housing Assembly (A+B) on a flat surface, tongue in and rotate the
Keypad Backer Sub-Assembly assembly into the Front Housing.
NOTE: Be careful when assembling (e.g. DO NOT touch the seal) so that the Speaker Compartment
Seal does not drop off from the Keypad Backer Sub-Assembly (15) resulting in a pinched or
improperly assembled seal leakage.
13. With the flip housing of the radio facing down, assemble all 4 screws with a Torx T6 bit torque
driver at 3.1 in-lbf in the below sequence.
14. Align and Assemble the Main Seal (19) to the Keypad Backer Sub-Assembly (15).
Section "8.7 Radio Reassembly" on page
Press
Figure 8–30. Reassemble Flip Flex
3
4
Figure 8–31. Assemble T6 screws to Front Housing
Disassembly/Reassembly Procedures: Radio Reassembly
8-17. Remove the 2 liners from the
1
2
Figure 8–30, plug the