JR
Refit the bearings cups on the housing side of the
mechanism using a 60 mm diameter tube.
REPLACING THE BEARING ON THE JR CLUTCH
HOUSING
Cut the base of the plastic hollow needle located at the
centre of the bearing.
Fit tool B. Vi. 1165 and extract the bearing.
MANUAL GEARBOX
Repairing the gearbox
Refit the bearing using tool B. Vi. 1167.
19815
Drive out the primary shaft bearing cup using a 38 ∅
extractor.
Refit this on the press using a 46 ∅ tube.
21-20
21
19814
19813