Renault Twingo Clio Workshop Repair Manual page 33

Table of Contents

Advertisement

Apply a line of Loctite 518 to the gasket face.
rd
Engage 3
gear.
Introduce the housing while guiding the control shaft
rd
into 3
gear, fit the locking spring and ball as the 5
gear shaft appears.
Press down the locking ball and finish fitting the
housing.
Remove tool B. Vi. 1570.
Tighten the peripheral bolt to a torque of 2.5 daNm
after rotating the primary shaft to ensure correct
alignment of the bearings.
Fit the reverse gear shaft (A).
MANUAL GEARBOX
Repairing the gearbox
On the secondary shaft:
Put three drops of Loctite Frenbloc on the splines of
the fixed gear and fit it using tool B. Vi. 1175.
th
On the primary shaft, fit:
– the support washer (top side gear side),
19808
– the sprocket bush,
– the 5
– the 5
21-31
th
idle gear fitted with its synchro ring,
th
gear hub fitted with its spring.
21
19807
19806

Advertisement

Table of Contents
loading

This manual is also suitable for:

Clio laguna iiLaguna ii

Table of Contents