Using The Manual Gearbox - Fiat Ducato Owner's Manual

Hide thumbs Also See for Ducato:
Table of Contents

Advertisement

USING THE MANUAL GEARBOX

DASHBOARD
AND CONTROLS
To engage the gears, press the clutch pedal fully and shift
the gear lever into one of the required positions (the di-
agram is shown on the knob, fig. 149).
To engage 6
SAFETY
by pressing it towards the right in order to avoid engag-
th
ing 4
gear by mistake. The same applies to the shift from
th
th
6
to 5
gear.
STARTING
IMPORTANT Reverse may only be engaged when the ve-
AND DRIVING
hicle is at a standstill. With the engine running, wait for
at least 2 seconds with the clutch pedal fully pressed be-
fore engaging reverse to prevent damage to the gears and
WARNING LIGHTS
grating.
AND MESSAGES
To engage reverse R from neutral, proceed as follows:
raise ring A under the knob and at the same time move
the gear lever to the right and then backwards.
IN AN EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
INDEX
fig. 149
144
th
gear (where provided), operate the lever
Press the clutch pedal fully to change
gears correctly. For this reason, there must
be no obstacles on the floor under the pedals: en-
sure that rubber mats (if any) are correctly po-
sitioned, not interfering with the pedals.
Do not drive with your hand resting on the
gear lever, because this pressure, even if
light, over time can wear out the gearbox
inner components.
F0N0074m
WARNING

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents