“Universal Isofix” Child Restraint Assembly Setup - Fiat Ducato Owner's Manual

Hide thumbs Also See for Ducato:
Table of Contents

Advertisement

Below is a summary of the rules of safety to
DASHBOARD
be followed for carrying children:
AND CONTROLS
1) The recommended position for installing child seats is
on the rear seat, as it is the most protected area in the
event of a crash.
SAFETY
2) If the passenger's air bag is deactivated always check
the amber warning light on the control panel to make sure
that it has actually been deactivated.
STARTING
3) Carefully follow the instructions supplied with the child
AND DRIVING
restraint system which are mandatory by law. Keep the in-
structions in the vehicle along with the other papers and
this handbook. Do not use second-hand child seats with-
out instructions.
WARNING LIGHTS
AND MESSAGES
4) Always check the seat belt is well fastened by pulling
the webbing.
5) Only one child is to be strapped into each retaining
IN AN EMERGENCY
system; never carry two children using one child seat.
6) Always check the seat belts do not fit around the child's
throat.
MAINTENANCE
7) While travelling, do not let the child sit incorrectly or
AND CARE
release the belts.
8) Never carry children on your lap, even newborns. No-
one, however strong, can hold a child in the case of an
TECHNICAL
accident.
SPECIFICATIONS
9) In case of an accident, replace the child's seat with
a new one.
INDEX
132
WARNING
Do not place a cradle seat facing back-
wards on the front seat if the passenger
side airbag is on. Deployment of the airbag in an
accident could cause fatal injuries to the baby re-
gardless of the severity of the collision. It is ad-
visable to carry children in an appropriate re-
straint system on the rear seat which is the most
protected position in the event of an accident.
"UNIVERSAL ISOFIX"
CHILD RESTRAINT ASSEMBLY SETUP
Provision has been made on the vehicle to fit a Universal
Isofix child restraint system, a new European standardised
system for carrying children safely. An example of a child
seat is shown in fig. 141. Due to its different anchoring sys-
tem, the Universal Isofix child's seat shall be anchored to
the proper lower metal rings A-fig. 142, set between rear
seat back and cushion. The upper belt (provided with the
child's seat) must be then secured to ring B-fig. 143 set
on the rear at child's seat level. It is possible to mount at
the same time both the traditional restraint system and
the "Universal Isofix" one.
Remember that in case of Universal Isofix child's seat, you
can only use all those seats approved with the marking
EKE R44/03 "Universal Isofix".

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents