Manual Gearbox; Automatic Transmission - Fiat TIPO 5DOOR Owner's Handbook Manual

MANUAL GEARBOX

114)
42)
To engage the gears, press the clutch
pedal fully and put the gear lever into
the required position (the diagram for
gear engagement is shown on the knob ).
110
th
To engage 6 gear (if present), operate
the lever by pressing it towards the right
th
in order to avoid engaging 4
mistake. The same applies to the shift
th th
from 6 to 5 gear.
1.3 Multijet 95 HP versions: To
engage reverse gear R from neutral,
press the clutch pedal and
simultaneously move the lever to the
right and then backwards.
1.4 95 HP versions: To engage
reverse R from neutral, lift the ring 1
fig. 110 under the knob and at the
same time move the lever to the right
and then backwards.
1.4 T–jet 120 HP / 1.6 Multijet
120 HP / 1.6 Multijet 115 HP
versions: To engage reverse R from
neutral, lift the ring 1 fig. 110 under the
knob and at the same time move the
lever to the left and then forwards.
IMPORTANT Reverse can only be
engaged when the vehicle is completely
stationary.
WARNING
114) Depress the clutch pedal fully to
change gear correctly. It is therefore
07056J0001EM
essential that there is nothing under the
pedals: make sure the mats are lying flat
and do not get in the way of the pedals.
gear by
IMPORTANT
42) Do not drive with your hand resting on
the gear lever as the force exerted, even if
slight, could lead over time to premature
wear of the gearbox internal components.
AUTOMATIC
TRANSMISSION
(where provided)
115) 116) 117)
43) 44)
GEAR LEVER
The fig. 111 lever has the following
positions:
P = Park
R = Reverse
N = Neutral
D = Drive, (automatic forward speed)
AutoStick: + shifting to higher gear
in sequential driving mode; – shifting to
lower gear in sequential driving mode.
111
The diagram for gear engagement is
shown on the trim at the side of the
gear lever.
The gear engaged is shown on the
display.
07076J0002EM
107