Configure The Pos Module - Motorola BSR 64000 Quick Start Manual

Refer to the following documents for additional instructions:
•
BSR 64000 Configuration and Management Guide
•
BSR 64000 Command Reference Guide

Configure the POS Module

Follow these steps to configure the POS module:
1. To configure the physical Packet Over SONET (POS) interface, use the interface
pos command in Global Configuration mode, as shown in the example below:
BSR(config)#interface pos <slot>/<port>
where:
2. To enter the IP address and subnet mask for the POS interface, use the ip-address
command in Interface Configuration mode, as shown in the following example:
RDN(config-if)# ip-address {<ip-address> <subnet-mask>}
where:
3. To enable the internal clock on the POS module, use the pos internal clock source
command in Interface Configuration mode, as shown in the following example:
BSR(config-if)#pos internal clock source
Note: If the clocking source is different for your implementation, refer to the
BSR 64000 Configuration and Management Guide
slot is the POS module slot on the BSR.
port is the POS interface on the POS module.
ip-address is the IP address designated for the POS interface.
subnet-mask is the subnet mask designated for the POS interface.
Quick Start
for more information.
11